This Universal LED Load Equalizer is required wherever LED Signals have been used to replace normal incandescent/halogen bulbs. Most cars and motorcycles monitor the resistance in the turn signal circuit and will increase the flash rate when it senses too little resistance. The system was designed this way so the driver will know when a bulb has burnt out but it will also flash faster if LEDs are installed since they have almost no load (resistance).

This unit will increase the load presented to the system so it will use the proper flash rate.

This Load Equalizer is encased in a waterproof aluminum housing complete with heat sink fins to dissipate heat and operate at a safe temperature. It dimensions are approx 1" x .5" x .5"

This three wire system is incredibly easy to install with the included wire tap connectors. The only tool you will need is a pair of normal pliers. Connect one wire to each of the positive signal leads and the third wire to ground or one of the negative leads. That's it!

This one unit will correct the flash rate for the turn signals on both sides of either the front or rear of your motorcycle or car. Front Left and Front Right -OR- Rear Left and Rear Right. You will need two units if you replaced your stock signal bulbs in both the front and rear.

Other sites sell equalizers that are twice as big, run hotter, and you will need to install one unit for each light! That could end up costing you four times as much!

Works on Honda, Yamaha, Kawasaki, Suzuki, Harley Davidson and others. Installation instructions included.